primary winding

英 [ˈpraɪməri ˈwɪndɪŋ]

美 [ˈpraɪmeri ˈwɪndɪŋ]

一次绕组；原绕组

电力

英英释义

noun

• coil forming the part of an electrical circuit such that changing current in it induces a current in a neighboring circuit
  1. current through the primary coil induces current in the secondary coil
  Synonym:primary coilprimary

双语例句

• Analysis of an Oil-Immersed Current Transformer Primary Winding Failure
  油浸式电流互感器一次绕组故障实例分析
• Study of Novel High Efficiency Single-phase Induction Motor with Three Series-connected Windings Relation between Relay Protection and Distribution of Secondary Winding and Outlet Way of Primary Winding in Current Transformer
  新型三绕组高效单相感应电动机研究电流互感器二次绕组排列及一次绕组出线方式与继电保护的关系
• The influence between Section spacing of secondary winding, primary winding and flux leakage of magnetic core to the secondary winding are simulated, the equivalent factor is introduced between the rectangular wire and the round wire.
  模拟分析次级绕组段间距、初级绕组以及磁芯漏磁对次级绕组损耗的影响，并引入了矩形导线和圆导线之间的等效因子。
• The transformer adopts multiple secondary compensation winding structure. The primary winding is in parallel with the harmonic load and the secondary compensation windings are connected with PWM inverters.
  变压器采用副方多补偿绕组结构，原方绕组与谐波负载相并联，副方补偿绕组分别与逆变器相联。
• The harmonic compensation currents proportional to the harmonic current in the primary winding, which is detected real-timely, are injected to the multiple secondary winding of the transformer.
  实时检测变压器原方绕组的谐波电流，通过逆变器产生与原方绕组谐波电流成比例的谐波补偿电流注入变压器副方多补偿绕组中。
• The strength calculation method and the structure of current transformer with U primary winding to fulfil the dynamic stability requirements are introduced, and some calculating examples are given.
  介绍了U形一次绕组电流互感器可满足动稳定要求的结构及强度计算方法，并给出了计算实例。
• Giving out the method for calculating and selecting fundamental performance parameters, such as primary current, primary winding, secondary current, secondary load, time constant and so on.
  给出了TA的主要参数，如一次电流、一次绕组、二次电流、二次负荷、时间常数等的选择和计算方法。
• The unbalanced degrees of current in primary winding under different load conditions are discussed, which are based on the general expressions of negative phase sequence current.
  结合负序电流的通用表达式，讨论了在不同负荷条件下的原边电流不平衡度。
• The High Tension ( HT) voltage is produced by mutual induction between the primary winding and the secondary winding, and the central soft iron core intensifies the magnetic field between them.
  通过初级绕组和次级绕组之间的互感产生出一个高电压，把两绕组联系起来的中心软体起导磁的作用，它把磁场集中起来。
• This paper introduces the importance of rising current at CT Primary Winding to the relay circuit check. And the method of rising current at CT primary winding and its application for switch and transformer bushing CTs in all kinds of operating modes are presented.
  讲述了电流互感器一次升流在继电保护回路验收中的重要性，并介绍了各种运行方式下开关CT与变压器套管CT一次升流的应用方法。